RADVision Scopia XT1000 Installation Guide download pdf (Page 27)

'Hardware Setup' | 23

RADVISION | Installation Guide for SCOPIA XT1000 Version 2.0

Connecting a Computer

To share data during a call, connect a computer to the DVI-I IN socket of the Codec Unit.

Procedure

Step 1 (For computers and laptops with a DVI out connector) Connect the DVI cable to the DVI-I socket

of the Codec Unit and connect the other end of the cable to the computer.

Step 2 (For computers with VGA out only) Use the DVI to VGA adapter:

1. Connect the DVI-VGA adapter to the DVI-IN socket of the Codec Unit.

2. Connect a VGA cable to the adapter. This cable does not ship with the system.

3. Connect the VGA cable to the PC/Laptop VGA out socket.

Step 3 Connect the computer audio to the Codec Unit.

• Since audio input is not included in the DVI-I port connection to the Codec Unit, establish a

separate audio connection from the computer’s audio output port into the S/PDIF audio

input port of the Codec Unit.

• If the computer does not support digital audio, you may need an external converter (see

Connecting an Analog Audio Equipment page 15).

Installing the Batteries of the Remote Control Unit

Procedure

Step 1 Slide the battery compartment cover open.

Step 2 Put the battery in, making sure the battery’s positive side faces up.

Step 3 Slide the battery compartment cover back until you hear a click.

When the Remote Control Unit's battery power is low, an icon appears on the GUI letting you know

that you should replace the battery:

• Half-charged Battery

• Low Battery

Note: When the Low Battery icon appears on the display, we recommend to change batteries

immediately, to ensure proper functioning of the system.

For battery disposal information refer to the Safety Instructions leaflet.

1 2 ... 22 23 24 25 26 27 28 29

No comments

RADVision Scopia XT1000 Installation Guide Page 27