RADVision Scopia Elite 5100 Series Installation Guide download pdf (Page 28)

Setting up the MCU | 24

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7

Removing the Cage Nut Screws

The cage nuts are supplied with pre-mounted screws. Remove the screws and put them aside for

later. See Figure 4-10 on page 24.

Figure 4-10 Removing the cage nut screw

Mounting the Device-fixing Cage Nuts

After you have marked the location of these cage nuts on the front-facing posts, you can mount

them into the rack. Insert each cage nut on each of the posts where you have placed marks on

the rack.

Procedure

Step 1 Rotate the bottom cage nut so that its wings are on the top and bottom sides of the cage nut. See

Figure 4-9 on page 23.

Step 2 Compress the wings. From the back side of the post, insert first the wide wing, then the narrow

wing into the marked square hole. Release the wings after the nut is in position.

Mounting the MCU onto the Shelf

After you have inserted the cage nuts onto the posts, you can mount the device onto the rack.

Before mounting the device, read the Safety Guidelines described in the Safety Guide. Secure the

device on the rack’s posts to prevent it from moving around or falling.

Warning

The device is heavy and we recommend that you ask someone to help you lift it.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 56 57

No comments

RADVision Scopia Elite 5100 Series Installation Guide Page 28