RADVision Scopia Elite 5100 Series Installation Guide download pdf (Page 34)

Performing the MCU Initial Configuration | 30

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7

Procedure

Step 1 Connect the serial cable from the PC terminal to the serial port on the front panel of the MCU.

Step 2 Connect the power cable.

Step 3 Start the terminal emulation application (such as SecureCRT or PuTTY) on the PC.

Step 4 Set the communication settings in the terminal emulation application on the PC as follows:

• Baud rate: 9600

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: None

Step 5 Turn on the power to the MCU.

A log of the auto-boot events scrolls across the computer monitor.

Step 6 When the message “Please press Enter to activate this console” appears on the screen, press

Enter within 10 seconds.

The network configuration Main menu appears (Figure 5-1 on page 30):

Figure 5-1 Main Menu

Caution If you do not press a key before the countdown ends, the device continues its initialization and you

will need to reboot the device to return to the network configuration Main menu.

Step 7 Enter N at the prompt to configure network port values and press Enter.

Step 8 Enter 2 to change the network configuration.

Step 9 (Optional) Enter Y at the prompt to enable IPv6 in addition to IPv4.

Step 10 (Optional) Enter Y at the prompt to enable IP separation.

Step 11 Enter the IP address you want to assign to the MCU at the IP address prompt and press Enter (see

Figure 5-2 on page 31).

Caution Do not use leading zeros in the IP address.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 56 57

No comments

RADVision Scopia Elite 5100 Series Installation Guide Page 34