RADVision Scopia Elite 5100 Series Installation Guide download pdf (Page 30)

Setting up the MCU | 26

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7

Figure 4-12 Securing the MCU to the rack

Attaching the System Ground

Note: WARNING - Before connecting power to the device or turning it on, provide it with an adequate

connection to a grounding point at the site. Contact the appropriate electrical inspection authority

or an electrician if you are uncertain that suitable grounding is available on the site.

The MCU grounding stud is located on the rear panel.The grounding equipment is user supplied.

Make sure to use an18 AWG (1 mm

) or larger grounding wire and appropriate grounding lug. The

length of the grounding wire depends on the MCU location or on the site environment.

Connecting Cables to the Device

Follow the safety guidelines described in the Safety Guide during this procedure, and use the

power, network, and serial cables supplied with the accessories kit.

Procedure

Step 1

Connect the power cable:

a. Turn off the power distribution unit (PDU).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 56 57

No comments

RADVision Scopia Elite 5100 Series Installation Guide Page 30